Constructing a Retaining Wall: How To Guide

Constructing a Retaining Wall

This past summer, I re-designed a raised planting bed that was constructed out of an old railroad tie retaining wall that was decaying and crumbling over time. I had the opportunity of watching the crew at work, so I figured I would share the installation process with you. There is a correct method of installing the wall to ensure that it is going to be functional and permanent. I used the Nicolock Firma Wall System Toffee/Onyx stone for this particular project, but if you are using another material, such as natural stone, the process is similar.

Step 1: Excavate soil and build base

Step 1: Excavate soil and build base

First, the original railroad tie wall had to be demolished and removed, while the soil around the perimeter area had to be excavated. It is important to dig down the equivalent of one course of block (eight inches in this case) and use a leveling device to obtain an even base. Add a recycled concrete layer under where the wall stone is going, approximately two-three inches at a time, and use a tamper to compact it. (If starting from scratch, it is recommended to use the recycled concrete as a base under the entire area where the topsoil is going and also use a layer of fill in between the topsoil and base to ensure proper drainage.) Select your wall blocks and lay them out across the base. Continue laying the stone block by block until the entire perimeter is created. Measure and make cuts with a masonry saw to complete any angles needed to fit the pieces together at the corners. This first step in construction takes the longest and is most crucial in determining the success of the rest of your project.

Step 2: Continue Adding Second Course

Step 2: Continue Adding Second Course

Continue with the second course. Select your wall system blocks and stack them in a staggered pattern on top of the base course so that the seams are overlapping. Dry-fit each block first so that the vertical joints are staggered as seen above. This creates a stronger and more stable wall.. Remove the block and apply a layer of mortar on the first course. Add the next course and tamp the block into place with a mallet, and repeat.

Step 3: Mortar the Layers

Step 3: Mortar the Layers

Continue building courses. At the third level, insert a drain pipe, while leaving an exit point for the drainpipe at one end of the wall. This will ensure proper drainage once your wall is complete. Continue the process while carefully aligning the block in a staggered pattern and mortar the layers until the desired height is obtained. Note that the final and top layer is the wall capping, a more decorative layer that prevents moisture from running down into the  open cracks of the lower layers and which adds the aesthetically pleasing finishing touch! Mortar the wall cap in place as you did for the other courses.

Constructing A Retaining Wall: Finished Project

Constructing A Retaining Wall: Finished Project

Depending on the size of the wall, a project like this can take anywhere from a couple of days to a week or more, but it is worth the while to take your time and have good results. Once your wall is constructed, bring in new organic topsoil and plantings to complete the project.

For more gardening tips and design ideas, see my books on Amazon:

A Guide to Northeastern Gardening: Journeys of a Garden Designer Zones 3-9
Landscape Design Combinations

Author:  Lee@Landscape Design By Lee 2018. All Rights Reserved.2c425-page2bdivider

Advertisements

Comments:

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s